Quantum Composers LDDC 1550 - Manual (Page 18)

8-18 | P a g e
LDDC/LSC Command Summary
Address Command Parameter Query Response Description
;DC
Diode Controller address which is
required before any/all subsequent
commands.
:BC 1 - 65535 1-65535
Sets and/or queries the burst count
feature.
:CB?
0 = Open
1 = Closed Query Only. Returns the Crowbar
status.
:CM?
0 to max
current(up to 3
decimal places)
Query Only. Returns the Current
Measurement.
:CS
0 - Max
Current
0 - Max Current
Sets and/or queries the Current Setting
(Up to three decimal places).
:CV 0 - 99 0 - 99
Sets and/or queries the Compliance
Voltage (Up to one decimal place).
:DC
0.0001 –
99.99999
(1)
0.0001 –
99.99999
(1)
Sets and/or queries percentage duty
cycle of pulsed output.
(1)
:DT 0-10
0 = Custom
1 = LDD<2000W
2 = LDD>2000W
3 = LDDHC
4 = LDDQCW-50
5 = LDDQCW>50
6 = LDY
7 = LDYHC
8 = XLB
9 = LDQPC
10 = LDPC
Sets and/or queries the type of external
Lumina Diode Driver.
:EN 0 or 1
0 = Disable
1 = Enable
Sets and/or queries the Enable signal.
:IB 0 or 1
0 = Disable
1 = Enable
Bypasses and/or queries the external
interlock control so it is always in a
closed or shorted state.
:IC 0 or 1
0 = Open
1 = Closed Sets and/or queries Interlock Control
feature.
:ID?
Ex: Quantum
Composers,1550,
1234,0.21.
Identification. Will return an
identification string in the format of
“Company,Model,Serial
number,Firmware version”.
:MC 1 - 999 1 - 999
Sets and/or queries the Maximum
Current (Refer to Diode Driver section)