Orion System HB Controller - Manual (Page 16)

Zone
Zone
Programming
16 HB Controller Technical Guide
Program Time
Line #2 displays the time, in 24-hour (military) format, that the HB
Controller software was created.
Program Version
Line #2 displays the HB Controller software version number.
Reset Counts
Line #2 displays the total number of times the HB Controller has been
reset or has had its power cycled.
Fan Module Status Screens
The Fan Module Status Screens are accessed by navigating to the Fan
Module and pressing the ENTER key. The following screen will then
appear:
Select “Status” by pressing the ENTER key. Press the up and down
SELECT arrow keys to move forward and backward through the Fan
Module Status screens.
Fan Terminal Active
Line #2 displays “YES” if there is a 24 VAC signal connected to the
“G” Fan terminal on the HB controller.
Fan Status
Line #2 displays the current Supply Fan Status. If the Supply Fan is on,
line #2 displays either “Fan Low Speed” or “Fan High Speed.” Line #2
displays “ON” if the High Speed Fan Relay is active.
Supply Fan Analog Output Signal
Line #2 displays the current Supply Fan Analog Output Signal in DC
Volts.
Fan Module Setpoint Screens
The Fan Module Setpoint Screens are accessed by navigating to the
Fan Module and then pressing the ENTER key. The following screen
will then appear:
Press the down SELECT arrow key until “Setpoints” is on the top line
of the screen and then press the ENTER key. Press the up and down
SELECT arrow keys to move forward and backward through the Fan
Setpoint screens.
Please see the Appendix section in the back of this manual for Tables
listing the minimum, maximum, and default setpoints for all of the
setpoint screens.
Supply Fan Confi guration
Select the appropriate Supply Fan Confi guration by using the up and
down ADJUST arrow keys and then pressing the ENTER key. Available
options are Two-Speed or Adj. Two-Speed.
Programming with the HB Service Tool