Orion System HB Controller - Manual (Page 15)

Programming
15 HB Controller Technical Guide
The other available module screens are listed below in the order that
they would appear as you scroll down.
Factory Options should not be accessed without contacting AAON ®
or WattMaster.
Warning: The Factory Options settings should only be ap-
plied when authorized by AAON ® or WattMaster
Technical Support personnel. Serious damage to the
controller and/or HVAC unit could result from im-
proper use of the Factory settings.
HB Controller Status & Setpoints
The Status and Setpoint screens for the various modules are accessed by
selecting a specifi c module and pressing the ENTER key.
Main Status Screens
The Main Status Screen is accessed by selecting the Main Status Module
and pressing the ENTER key. This screen, as its name indicates, allows
you to view the Main Status screens for the HB controller. After the
ENTER key is pressed, the following screen will be displayed:
HVAC Mode
Line #2 displays one of the following HVAC Modes:
• Idle • Venting
• Cooling • Econo Cooling
• Heating • Dehumidify
• Econo Dehumidify • Fault
• Force
Press the down SELECT arrow key or up SELECT arrow key to move
forward or backward through the Main Status screens.
OAT Heat Lockout
Line #2 displays “YES” if the Outdoor Air Temperature is above the
Heating Lockout Temperature Setpoint.
OAT Cool Lockout
Line #2 displays “YES” if the Outdoor Air Temperature is below the
Cooling Lockout Temperature Setpoint.
OAT Temperature
Line #2 displays the current Outdoor Air Temperature.
SAT Temperature
Line #2 displays the current Supply Air Temperature.
Alarms
Line #2 displays “YES” if an alarm is active. To identify the active
alarm(s), press the ESC key, select the Alarm Module, and scroll through
the available alarms using the up and down SELECT arrow keys.
Program Date
Line #2 displays the Month/Day/Year that the HB Controller software
was created.
Programming with the HB Service Tool