Olson Technology OTEB-CW-B - Manual (Page 38)

35
RS-232 Command Code Units Notes
Bit 9 - Input Off Alarm
Bit 10 - Interlock
Bit 11 - Power Supply 1 Failed Alarm
Bit 12 - Power Supply 2 Failed Alarm
Bit 13 - Reserved
Bit 14 - Emission On
Bits 15 - 31 are reserved.
Read Relay Alarm Status RRAS - Returns the alarms that are assigned to trip the alarm relay.
Read Relay Status RRS - Returns the state of the relay “Normal” or “Tripped”
Read Alarm Status RAL - Returns the individual alarm conditions within the Laser.
Read “Output Power High” Alarm Level RPOUTHIGH dBm Returns: “Pout High Alarm Level = xx.x”
NOTE: this value could be negative and/or have 2 digits containing 1 deci-
mal point; i.e. –12, -2.2, 0.0, 3.5
Read “Output Power Too High” Alarm
Level RPOUTTOOHIGH dBm Returns: “Pout Too High Alarm Level = xx.x
NOTE: this value could be negative and/or have 2 digits containing 1 deci-
mal point; i.e. –12, -2.2, 0.0, 3.5
Read Minimum Current Adjust when in
ACC Mode RACCNUDGEMIN Amps *Returns “ACCNudgeMin = x.xxx”
Read Maximum Current Adjust when in
ACC Mode RACCNUDGEMAX Amps *Returns “ACCNudgeMax = x.xxx”
Read Current Adjust Step Size when in
ACC Mode RACCNUDGESTEP Amps *Returns “ACCNudgeStep = x.xxx”
Read Minimum Power Adjust when in APC
Mode RAPCNUDGEMIN dBm *Returns “APCNudgeMin = xx.x dBm”
Read Maximum Power Adjust when in APC
Mode RAPCNUDGEMAX dBm *Returns “APCNudgeMax = xx.x dBm”
Read Power Adjust Step Size when in APC
Mode RAPCNUDGESTEP dB Returns “APCNudgeStep = xx.x dBm”
Read Minimum Gain Adjust when in AGC
Mode RAGCNUDGEMIN dB Returns “AGCNudgeMin = xx.x”
Read Maximum Gain Adjust when in AGC
Mode RAGCNUDGEMAX dB Returns “AGCNudgeMax = xx.x”
Read Gain Adjust Step Size when in AGC
Mode RAGCNUDGESTEP dB Returns “AGCNudgeStep = xx.x”
Read Default Minimum Current Adjust
when in ACC Mode RFDACCNUDGEMIN Amps Returns “FD ACCNudgeMin = x.xxx”
Read Default Maximum Current Adjust
when in ACC Mode RFDACCNUDGEMAX Amps *Returns “FD ACCNudgeMax = x.xxx”
Read Default Minimum Power Adjust when
in APC Mode RFDAPCNUDGEMIN dBm *Returns “FD APCNudgeMin = xx.x dBm”
Read Default Maximum Power Adjust
when in APC Mode RFDAPCNUDGEMAX dBm *Returns “FD APCNudgeMax = xx.x dBm”
Read Default Minimum Gain Adjust when
in AGC Mode RFDAGCNUDGEMIN dB *Returns “FD AGCNudgeMin = xx.x”
Read Default Maximum Gain Adjust when
in AGC Mode RFDAGCNUDGEMAX dB *Returns “FD AGCNudgeMax = xx.x”
*= Applies to models with front panel LCD Only