Set stop time, Exit program mode, View program – MovinCool CMW30 User Manual
Page 46: Set stop time exit program mode view program, Operation (wall mounted controller only) (cont.)
46
OPERATION
(Wall Mounted Controller ONLY) (cont.)
Set Stop Time
11. Press UP (
) or DOWN (
) button to select “Day
of the week”.
Press ENTER button. “Hour” blinks.
12. Press UP (
) or DOWN (
) button to select “hour”.
Press ENTER button. “Minutes” blinks.
Note: AM or PM changes with hour automatically.
13. Press UP (
) or DOWN (
) button to select
“minutes”. Press ENTER button. “Pr 02” illuminates.
Note: To change the previous settings, press
RESET button and start again from “Day of the
week” setting.
Repeat step 1. to 13. to set up program sequences from “Pr 02” to “Pr 10”.
Note: Program counts period from the start time and day of “Pr 01” to the stop time
and day of the last program. Program period can not be overlapped. Overlapped
time period input can not be accepted by the controller.
Exit Program Mode
14. Press PROGRAM button for 3 seconds to exit program mode.
View Program
1. Press PROGRAM button.
2. Press UP (
) or DOWN (
) button to select the desired program sequence.
3. Press ENTER button. Detail of “ON” program (start time and operation mode
setting) is displayed.
4. Press ENTER button. Detail of “OFF” program (stop time) is displayed.
5. Press ENTER button. Returns to the select program view.
6. Press PROGRAM button to exit.
ILL00314-00