Supplied wall mounted controller connection, Installation (cont.) – MovinCool CMW30 User Manual

Page 26

INSTALLATION (cont.)

Supplied Wall Mounted Controller Connection

Set up the wall mounted controller without power connection on the unit.

Otherwise, the wall mounted controller set up will not be completed.

WARNING:

1. All electrical work should only be performed by qualified personnel.

Repair to electrical components by non-certified technicians may

result in personal injury and/or damage to the unit.

2. Disconnect power before any electrical installation. Beware that

some residual voltage may remain in the unit immediately after the

power is disconnected.

3. Do not touch the relay board of the unit until the green LED7 is

turned off. Failure to follow this warning may lead to electrical

shock.

Note: When the wall mounted controller of other model is connected, the lowest

set point temperature is 60 °F (16 °C). The model name label is attached on the

controller’s back cover.
1. Push the stopper located at the bottom of the controller. Then remove the front

cover.

LED 7

ILL00697-00

Relay Board

FRONT COVER

STOPPER

ILL00292-00