MovinCool CMW30 - Manual (Page 11)

11
INSTALLATION (cont.)
Mounting CMW30 to Roof Structure
Be sure to securely anchor the top ends of the suspension rods. Make sure all nuts
are tight. Be sure to follow all applicable codes.
The unit is usually mounted above the ceiling and must be securely mounted to
the roof structure. The ceiling support of the existing building may require
reinforcements.
WARNING: Make sure the supporting roof structure is capable of
supporting the weight of the unit, mounting hardware and the
accessories. Roof structure should be able to support four times of
total weight or more. Unit weight is 236 lb (107 kg).
The recommended clearance between ceiling grids and building structural
member is the unit height plus 3.0 inch (76 mm).
All mounting hardware except vibration isolators is field supplied.
Use the following hardware.
Hardware (Quantity) Size
Threaded suspension rod (4) 1/2 in (Min. 236 lb (107 kg) load capability)
Nut (12) 1/2 in
Washer (4) 1/2 in
ILL00256-00