beautypg.com

Warning, Operation - model b-series dv-2, Removing and installing the door – Montigo B34DV User Manual

Page 15

background image

Page 15

B-Series DV-2 Gas Fireplace

Part No. XG0160 - 141231

Operation - Model B-Series DV-2

Removing and Installing

the Door

Removing the door:

Remove the trim (Figure 28) to access the door

latches. Open the latches by pulling Part A upwards and towards you

to disengage Part B from the door. Lift Part B clear of the door. Repeat

.l

la

f

t

o

n

s

e

o

d

ti

o

s

yl

lu

f

e

r

a

c

r

o

o

d

e

h

t

dl

o

h

o

t

e

r

u

s

e

B

.s

e

h

ct

al

h

t

o

b

r

o

f

Figure 27a. Removing and installing the glass door.

Figure 27. Removing and installing the glass door.

Figure 27b. Removing and installing the glass door.

Re in t ing the door:

o re install the door tilt the top edge towards you and line up the tabs

far as it will go. lose the latches by hoo ing Part B onto the groove at

the top of the door and pushing Part A down completely.

n t ing the og :

The 6 horizontal trim pieces (3 upper and 3 lower) are purchased separate

nstall the trim by placing the top edge of the trim over to the retainer

below.

he trim piece with the ontigo mblem should be installed on the lower

middle clips with the emblem on the right side.

Figure 28. Installing the Trim.

WARNING

When reinstalling door(s), always make sure all door

buckles are properly hooked and fully engaged.

WARNING

When installing the fireplace - gas lines, fittings,

accessories or any other objects cannot impede the

proper movement of the door buckles.

This manual is related to the following products: