Metz MECABLITZ 58 AF-2 digital Pentax User Manual

Page 139

139

19.3 Activating the remote flash mode as Slave

• Press the

button repeatedly until "Select"

appears on the display.

• Use the

and

buttons to select "Remote"

from the menu. The selected menu option is indica-

ted by a dark bar.

• Press the

button to confirm the selection of

"Remote".

• Use the

and

buttons to select "Remote

Slave". The setting is effective immediately.

• Press

repeatedly to return the display to normal.

If the

button is not pressed, the display will

switch back to normal automatically after approxi-

mately 5 seconds.

The Slave flash unit must be set to the same
remote channel as the Master or Controller flash
unit. The Slave flash mode (P-TTL remote) cannot
be set manually on the Slave flash unit, because
the Master and Controller flash units are control-
led automatically!

• Store the setting with the

button. If the button

is not pressed, the settings will be saved automatical-

ly after approximately 5 seconds.

☞

Set

Sel

Setting the parameters
• Press the

button repeatedly until the desired parameter appears on the

display. Here it is possible to make settings for...

- EV: Flash exposure correction; -3 EV to +3 EV in increments of one third are

possible

- Channel: Remote channel; channels 1 to 4 are possible
- and MZoom: Reflector position; 24mm (12mm with wide angle attachment)

up to 105mm are possible.

• Use the

and

buttons to make the desired settings.

• Store the setting with the

button. If the button

is not pressed, the set-

tings will be saved automatically after approximately 5 seconds.

19.4 Deactivating the remote mode

• Press the

button repeatedly until "Select"

appears on the display.

• Use the

and

buttons to select "Remote"

from the menu. The selected menu option is indicated

by a dark bar.

• Press the

button to confirm the selection of

"Remote".

• Use the

and

buttons to select "Remote

OFF". The setting is effective immediately.

• Press

repeatedly to return the display to normal.

If the

button is not pressed, the display will

switch back to normal automatically after approxi-

mately 5 seconds.

Set

Sel

–

Para

Select

BEEP

Remote

Set

☛

Remote

Slave

Set

☛

Para

Sel

SLAVE

GROUP:A

AZoom 35

CHANNEL:1

Select

BEEP

Remote

Set

☛

Remote

OFF

Set

☛

709 47 0237.A1 58AF-2 Pen/Sam 27.07.2010 15:17 Uhr Seite 139