Measurement Computing WBK20A - Manual (Page 9)

WBK20A, PCMCIA/EPP Interface Card 04-02-02 Windows 95/98/Me 2-3
Windows 95/98/Me
Setup for WBK20A Windows 95/98/Me
Reference Note:
This section only applies to Windows 95, Windows 98, and to Windows Me. If you are using
Windows 2000 or Windows XP , refer to the applicable section of this chapter.
1. Place the Data Acquisition CD into your CD ROM drive.
(a) If you have not yet installed product support for your device; i.e., WaveBook Support or
DaqBook Support, do so at this time. Consult your WaveBook or DaqBook documentation
as needed. After installation, with the CD still in the drive, continue with step 2.
(b) If you have already installed product support for your device, and if your CD drive has
auto-run, wait for the Master Setup Screen to appear, then click .
2. Insert the WBK20A, label-side up, into your computer’s PCMCIA adapter slot.
A dialog box should appear, indicating that Windows has begun the installation process for your
hardware; then the “Add New Hardware Wizard” will open, indicating that Windows is ready to install
drivers for the new hardware.
Add New Hardware Wizard, Intro Screen
3. Click . The Wizard will proceed to a second screen that pertains to how the new driver is to be
located. The Windows Me screen differs slightly from the Windows 9x screen, as can be seen in the
following figures.
Selecting, “Search for the best driver …”
(for Windows 95 and Windows 98)
Selecting, “Specify the location of the driver …”
(for Windows Me)
4. Windows 95/98 Users: Select the radio button that reads, “Search for the best driver for your device.”
Windows Me Users: Select the radio button that reads, “Specify the location of the driver.”