Measurement Computing WBK20A - Manual (Page 13)

WBK20A, PCMCIA/EPP Interface Card 04-02-02 Windows 2000 2-7
Windows 2000
Setup for WBK20A Windows 2000
Reference Note:
This section applies only to Windows 2000. If you are using
Windows 95, Windows 98,
Windows Me , or Windows XP , refer to the applicable section of this chapter.
1. Place the Data Acquisition CD into your CD ROM drive.
(a) If you have not yet installed product support for your device; i.e., WaveBook Support or
DaqBook Support, do so at this time. Consult your WaveBook or DaqBook documentation
as needed. After installation, with the CD still in the drive, continue with step 2.
(b) If you have already installed product support for your device, and if your CD drive has
auto-run, wait for the Master Setup Screen to appear, then click .
2. Insert the WBK20A, label-side up, into your computer’s PCMCIA adapter slot.
A dialog box should appear, indicating that Windows has begun the installation process; and a
“Found New Hardware Wizard” will open, indicating that Windows 2000 is ready to install drivers for
the new hardware.
Found New Hardware Wizard, Intro Screen
3. Click . The Wizard will proceed to a screen with the text, “Install Hardware Device Drivers”
(following figure).
Install Hardware Device Drivers Screen
4. Select the radio button that reads, “Search for a suitable driver for my device.”
5. Click . The “Locate Driver Files” screen appears (following figure).