Measurement Computing WBK20A - Manual (Page 31)

WBK20A, PCMCIA/EPP Interface Card 04-01-02 Testing the WBK20A Interface 5-3
4. Run the “Resource Test.”
(a) Click on the “Test Hardware” Tab. A screen similar to the following figure will appear.
Daq* Configuration, “Test Hardware” Tab
(b) Click the button. The utility will run the test and display the results. An
example of test results is included in the following figure.
Test Results
5. Check the “Test results.”
The Test Results (see previous figure) let you know if the WaveBook or DaqBook was detected,
and if the Base Address and Interrupt Level tests passed or failed. In addition, the test provides
performance information in terms of samples/sec. This is the maximum speed at which the data
was transferred.
If your Resource Tests “Passed,” click and close out of the Daq*Configuration Window.
If either Resource Test fails, refer to Symptom 2 in chapter 6, Troubleshooting.
This completes the WBK20A interface test.