Measurement Computing WBK20A - Manual (Page 12)

Windows 95/98/Me
2-6 Windows 95/98/Me 04-02-02 WBK20A, PCMCIA/EPP Interface Card
13. The Hardware Wizard will inform you when the installation is complete, as indicated in the following
figure. At that point click
Confirmation that the software has been installed.
This completes the Windows 95/98/Me Software setup for the WBK20A. You will need to reboot the
computer with the card installed.
The WBK20A is not a “Hot-Swap” card. To ensure proper operation of the WBK20A
card, boot up the computer only after verifying that the WBK20A is inserted in the PC’s
card slot. Failure to do so may prevent the application software from recognizing the card
as a parallel port device.
Reference Note:
In regard to connecting the WBK20A to the WaveBook or DaqBook, refer to chapter 3,
Connecting the WBK20A to Hardware .