Measurement Computing WBK20A - Manual (Page 26)

4-4 Port Assignment 04-02-02 WBK20A, PCMCIA/EPP Interface Card
The System Properties dialog will open (following figure).
3. Click on the “Hardware” tab.
4. Click the button.
Selecting “Device Manager” from
the Hardware tab in System Properties
5. In the Device Manager, expand the “Ports (COM & LPT)” node.
6. Look at the WBK20 [WBK20A] port designation. In the following figure we see that the
WBK20A is assigned to port LPT3. We will check for this port assignment in step 8. Also,
note that it will be needed for the interface test that is discussed in chapter 5.
Selecting the IOtech WBK20 Node from
Ports (COM & LPT) Expansion
The WBK20 node also
applies to WBK20A.