Measurement Computing Personal488 rev.1.0 - Manual (Page 27)

Personal488 for Windows 95/98/Me/NT/2000/XP 889496 Hardware Configuration Reference 4-1
Hardware Configuration Reference 4
Configuration Overview …… 4-1
AT488 Configurations …… 4-3
GP488B Configurations …… 4-7
GP488B/MM Configurations …… 4-11
Configuration Overview
Plug-and-Play Devices
Plug-and-play devices require no physical configuration of hardware. After installing your
software and hardware [as described in Chapters 2 and 3] the configuration is performed
automatically. Note that the plug-and-play devices are listed in the following table as a
product reference only. This chapter contains no useful information concerning plug-and-play
devices.
Non Plug-and-Play Devices
The I/O base address, IRQ, and DMA settings of non plug-and-play devices are determined
by the physical settings of jumpers and DIP switches. This chapter provides the information
necessary to configure these devices.
Plug-and-Play Devices Non Plug-and-Play Devices
PCI488 AT488
Automatic
Configuration.
See page 4-3.
AT488pnp GP488B
Automatic
Configuration.
See page 4-7.
CARD488 GP488B/MM
Automatic
Configuration.
See page 4-11.
Note: The device images are not shown to the same scale.