Measurement Computing Personal488 rev.1.0 - Manual (Page 2)

ii Personal488 User’s Manual for Windows95/98/Me/NT/2000/XP
Warranty Information
Your IOtech warranty is as stated on the product warranty card. You may contact IOtech by
phone, fax machine, or e-mail in regard to warranty-related issues.
Phone: (440) 439-4091, fax: (440) 439-4093, e-mail: [email protected]
Limitation of Liability
IOtech, Inc. cannot be held liable for any damages resulting from the use or misuse of this product.
Copyright, Trademark, and Licensing Notice
All IOtech documentation, software, and hardware are copyright with all rights reserved. No part of
this product may be copied, reproduced or transmitted by any mechanical, photographic, electronic,
or other method without IOtech’s prior written consent. IOtech product names are trademarked;
other product names, as applicable, are trademarks of their respective holders. All supplied IOtech
software (including miscellaneous support files, drivers, and sample programs) may only be used on
one installation. You may make archival backup copies.
CE Notice
Many IOtech products carry the CE marker indicating they comply with the safety and emissions
standards of the European Community. As applicable, we ship these products with a Declaration
of Conformity stating which specifications and operating conditions apply.
Warnings, Cautions, Notes, and Tips
Refer all service to qualified personnel. This caution symbol warns of possible personal injury
or equipment damage under noted conditions. Follow all safety standards of professional
practice and the recommendations in this manual. Using this equipment in ways other than
described in this manual can present serious safety hazards or cause equipment damage.
This warning symbol is used in this manual or on the equipment to warn of possible injury or
death from electrical shock under noted conditions.
This ESD caution symbol urges proper handling of equipment or components sensitive to
damage from electrostatic discharge. Proper handling guidelines include the use of grounded
anti-static mats and wrist straps, ESD-protective bags and cartons, and related procedures.
This symbol indicates the message is important, but is not of a Warning or Caution category.
These notes can be of great benefit to the user, and should be read.
In this manual, the book symbol always precedes the words “Reference Note.” This type of
note identifies the location of additional information that may prove helpful. References may
be made to other chapters or other documentation.
Tips provide advice that may save time during a procedure, or help to clarify an issue. Tips
may include additional reference.
Specifications and Calibration
Specifications are subject to change without notice. Significant changes will be addressed in an
addendum or revision to the manual. As applicable, IOtech calibrates its hardware to published
specifications. Periodic hardware calibration is not covered under the warranty and must be
performed by qualified personnel as specified in this manual. Improper calibration procedures may
void the warranty.
Quality Notice
IOtech has maintained ISO 9001 certification since 1996. Prior to shipment, we thoroughly
test our products and review our documentation to assure the highest quality in all aspects. In
a spirit of continuous improvement, IOtech welcomes your suggestions.