Measurement Computing ZonicBook Rev.3.0 - Manual (Page 9)

ZonicBook 11-01-01 Getting Started, pg. 5
Connecting and Powering a ZonicBook System
It is relatively easy to connect a ZonicBook system, and to supply power to it. The steps are as follows:
1. Insert the DSP-Card into your computer’s PCMCIA slot.
2. Connect the DSP cable to the DSP-Card.
3. Connect the ZonicBook to the DSP-cable.
4. Connect the Power Supply to the ZonicBook.
5. Connect the Power Cord to the Power Supply.
6. Connect the Power Supply to an appropriate power source.
7. Connect the computer to power.
8. Turn on the computer.
9. Turn on the ZonicBook.
A green Power ON LED (on the face of the unit) will light.
8-Chanel ZonicBook System
Cap unused BNCs to reduce extraneous noise, and to keep the connectors free of
dust and other debris.
DSP-Card with Cable
(DSP-Card, not shown, is in NoteBook’s
PCMCIA Slot)
ZonicBook
Data Acquisition Module
Power Supply
Notebook PC
with PCMCIA Slot
Power Cord