Measurement Computing ZonicBook Rev.3.0 - Manual (Page 7)

ZonicBook 11-01-01 Getting Started, pg. 3
Software Installation
1. Start Windows.
2. Close all running applications.
3. Insert the ZonicBook Suite CD into your CD-ROM drive and wait for it to auto-run (see note).
Note: The CD should run automatically, unless the computer’s CD auto-run feature is disabled.
If the CD does not start on its own:
(a) click the desktop’s button
(b) choose the Run command
(c) select the drive applicable to your CD-ROM drive
(d) click .
4. A Software and Manuals Selection Screen will appear, similar to the one shown in the
following figure.
Software and Manuals Selection Screen
5. Click the screen button that corresponds with your purchased software.
The Passwords for your software accompany your CD. You will need to enter the
passwords when indicated by the on-screen prompt.
6. Follow the on-screen directions to install your software.
7. Install other ZonicBook software programs, if applicable.
Note: In addition to installing software, you can use the Software and Manuals Selection Screen
(previous figure) to view Adobe PDF versions of ZonicBook documentation. Simply click the
button to access the document files.
Reference Note:
After your software is installed you can setup your ZonicBook Data Acquisition Module and
connect it to the host computer. Instructions for
Hardware Setup begin on page 4.