Measurement Computing ZonicBook Rev.3.0 - Manual (Page 20)

Getting Started, pg. 16 11-01-01 ZonicBook
12. Click .
The Hardware Wizard is now ready to install the DSP-card driver
(see following figure).
13. Click .
14. After the device driver has been installed, click (following figure).
This completes the driver installation for Windows Me. Your computer is now ready to run
ZonicBook software and communicate with the ZonicBook module.
Reference Note:
You can use the Windows Control Panel to verify that the DSP-card has been installed
correctly. See,
Verifying the DSP-Card has been Correctly Installed , on page 19.
Windows Me Users