beautypg.com

Measurement Computing ZonicBook Rev.3.0 User Manual

Page 26

background image

Getting Started, pg. 22

11-01-01

ZonicBook

If the DSP-Card does not respond in Windows NT, try the following:

1. From the desktop, open the Control Panel. This is done by navigating as follows:

Start

⇒ Settings ⇒ Control Panel ⇒ System ⇒ Device Manager ⇒ CACDSP

Note: “CACDSP” represents the DSP-Card device

2. Double-click the “CACDSP” (DSP-Card) device.

3. Click the button. This starts the DSP-Card without the need to reboot the computer.

4. To enable or disable the DSP-Card, click the button, then click the or the

button as applicable.

5. Click the button.

6. If the Startup method is not set to “Automatic,” set the DSP-Card for “Automatic” startup.

Windows NT Users

See also other documents in the category Measurement Computing Hardware: