Installing zonicbook drivers, Windows xp users, Installing zonicbook drivers …… 5 – Measurement Computing ZonicBook Rev.3.0 User Manual
Page 10: Windows xp users …… 6
Getting Started, pg. 6
11-01-01
ZonicBook
Installing ZonicBook Drivers
Only install the drivers that apply to your operating system.
To avoid installing the wrong driver, be sure to use the instructions that are intended for
your PC’s Windows system. Refer to the following sections as applicable.
Note:
If you have previously installed ZonicBook drivers, you should not need to do so again,
even if you are upgrading your software.
Windows XP Users
Prior to installing the drivers, be sure that your ZonicBook system is
properly connected and powered.
1. Insert the DSP-Card into your computer’s PCMCIA slot 0.
Windows XP will start the Hardware Wizard.
2. After the dialog box appears, verify that “Install from a list or specific location” is selected.
See following figure.
3. Click