Measurement Computing ZonicBook Rev.3.0 - Manual (Page 22)

Getting Started, pg. 18 11-01-01 ZonicBook
The driver’s location path should appear above the button (see following figure).
7. Click . A new dialog box should appear, as follows.
8. Click to begin the actual install.
9. Once the device driver has been installed, click .
This completes the driver installation for Windows Me. Your computer is now ready to run
ZonicBook software and communicate with the ZonicBook module.
Reference Note:
You can use the Windows Control Panel to verify that the DSP-card has been installed correctly.
See,
Verifying the DSP-Card has been Correctly Installed , on page 19.
Windows95/98 Users