Measurement Computing ZonicBook Rev.3.0 - Manual (Page 27)

ZonicBook 11-01-01 Getting Started, pg. 23
Starting the ZonicBook
The ZonicBook system is ready for use once the tasks in the following checklist have been completed.
❑ Software Installed (pg. 3)
❑ Channel DIP-switches Set (pg. 4)
❑ Hardware Connected and Powered ON (pg. 5)
❑ Drivers Installed (pg. 6)
❑ Signal Lines Connected to ZonicBook BNC Connectors for Channel Input
❑ Unused BNC Connectors Capped
To start the ZonicBook system:
1. On the Start Menu, select Programs.
2. Select ZonicBook.
3. Select the applicable ZonicBook software, e.g., eZ-Analyst, eZ-Balance.
Reference Note: Refer to the applicable document module in regard to software specifics.