Measurement Computing Digital232 - Manual (Page 7)

Section 1 Introduction
1.3
1.3 Specifications
DIGITAL I/O:
Configuration:
Five 8 bit ports, programmable as inputs or outputs.
Also included are programmable handshake lines, data
latching capability, and trigger output.
Logic Levels: Outputs will drive 2 TTL loads.
Connector: I/O Port: One 50 pin card-edge. Mating connector
supplied.
SERIAL INTERFACE:
EIA RS-232C:
AB, BA, BB, CA, CB
Duplex: Full with switch selectable echo/no-echo
Data Bits: 7 or 8 (switch selectable)
Stop bits: 1 or 2 (switch selectable)
Parity: Switch selectable on transmit for odd, even,
mark, space or disabled. No parity test on receive
Baud Rates: 110, 135, 150, 300, 600, 1200, 1800, 2400, 3600,
4800, 7200, 9600, and 19200 (switch selectable)
Terminator: Switch selectable CR, LF, CR-LF, or LF-CR
Control: Supports Clear To Send (CTS), Request To Send
(RTS) and switch selectable XON/XOFF
Serial I/O Buffers: 3500 Characters each
Serial Connectors: Mates with a 25-Pin Sub-D male: DCE configured.
GENERAL:
Indicators:
LEDs for Send, Receive, Test, Error, and Power
Power: 105-125V or 210-250V,50, 60 Hz; 15 VA MAX.
Environment: 0 to 50 deg C; 0 to 70% RH
Dimensions: 188mm deep x 140mm wide x 68mm high. (7.39" x
5.5" x 2.68")
Weight: 1.55 kg (3.6 lbs)
Controls: Power switch, internal dip switch for RS-232
parameters
Supplied Accessories: I/O port connector, power supply and manual.
Specifications are subject to change without notice.