beautypg.com

4 serial stop bit selection, 5 serial terminator selection – Measurement Computing Digital232 User Manual

Page 14

background image

Section 2

Getting Started

2.6

2.2.4 Serial Stop Bit Selection

Switch SW1-8 determines the number of stop bits contained in each serial

character transmitted and received. The factory default is 2 stop bits.

SW1 View for Serial Stop Bit Selection

2.2.5 Serial Terminator Selection

S2-3 and S2-4 select the serial terminators for the serial input and output. The

factory default is CR. (switch S2 is located near the rear power switch).

S2 View for Serial Terminator

See also other documents in the category Measurement Computing Hardware: