beautypg.com

Additional documentation, Unpacking the usb-pdiso8, Installing the software – Measurement Computing USB-PDISO8 User Manual

Page 9: Installing the usb-pdiso8, Connecting the external power supply, Additional documentation -2, Unpacking the usb-pdiso8 -2, Installing the software -2, Installing the usb-pdiso8 -2, Connecting the external power supply -2

background image

USB-PDISO8 User's Guide

Installing the USB-PDISO8

Additional documentation

In addition to this hardware user's guide, you should also receive the Quick Start Guide (available in PDF at

www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf

). This booklet supplies a brief description of

the software you received with your USB-PDISO8 and information regarding installation of that software.

Please read this booklet completely before installing any software or hardware.

Unpacking the USB-PDISO8

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the USB-PDISO8/40 from its packaging, ground yourself using a wrist strap or by

simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If any components are missing or damaged, notify Measurement Computing Corporation immediately by

phone, fax, or e-mail:

ƒ

Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

ƒ

Fax: 508-946-9500 to the attention of Tech Support

ƒ

Email:

[email protected]

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data
Acquisition Software CD

. This booklet is available in PDF at

www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf

.

Installing the USB-PDISO8

Before you connect the USB-PDISO8 to your computer, connect the external power supply that was shipped

with the device.

You can connect up to four compatible Measurement Computing USB products in a daisy chain configuration

to a single USB 1.1 port or USB 2.0 port on your computer.

Connecting the external power supply

Power to the USB-PDISO8 is provided with the +9 V external power supply (CB-PWR-9). You must connect

the external power supply before connecting the USB cable to the USB-PDISO8 and your computer.

If you are connecting more than one Measurement Computing USB product, make sure that you provide

adequate power to each device. Refer to the "Power limitations using multiple USB-PDISO8 devices" section

on page 3-7.

To connect the power supply to your USB-PDISO8, connect the external power cord to the power connector

labeled

POWER IN

on the USB-PDISO8 enclosure (

PWR IN

on the board). Refer to

on page 3-1 for

the location of this connector.

Figure 3-1

The

PWR

LED illuminates green when +9 V power is supplied to the USB-PDISO8. If the voltage supply is

less than +6.5 V or more than +12.5 V, the

PWR

LED does not light.

Do not connect external power to the POWER OUT connector
The power connector labeled

POWER OUT

on the enclosure (

PWR OUT

on the board) is used to provide power

to an additional Measurement Computing USB product. If you connect the external power supply to the

POWER OUT

connector, the USB-PDISO8 does not receive power, and the

PWR

LED does not illuminate.

2-2