Marantz SR6008 - Manual (Page 178)

178
Appendix Tips Playback Connections Contents
Front panel Display Rear panel Index Remote
Settings
Bass
Set subwoofer and LFE signal range playback.
2 Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE (Default) : The low range signal of the channel set to “Small”
speaker size is added to the LFE signal output from the
subwoofer.
LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer. This is usually the best
setting for most systems.
%
• “Subwoofer Mode” can be set when “Speaker Config.” – “Subwoofer”
(vpage 174) is set to other than “No”.
• Play music or a movie source and select the mode offering the strongest
bass.
• If “Front” and “Center” for “Speaker Config.” (vpage 174) are set to
“Large”, and “Subwoofer Mode” is set to “LFE”, no sound may be output
from the subwoofers, depending on the input signal or selected sound mode.
Select “LFE+Main” if you want the bass signals to always be produced from
the subwoofer.
2 LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz
Front Speaker
Set the front speakers to use.
%
• This can be set when “Assign Mode” (vpage 173) is set to “Front B”.
A (Default) : Front speaker A is used.
B : Front speaker B is used.
A+B : Both front speakers A and B are used.