Marantz SR6008 - Manual (Page 110)

110
Appendix Tips Settings Connections Contents
Front panel Display Rear panel Index Remote
Playback
Direct playback
Sound recorded in source is played as is.
1 Press PURE to select “DIRECT”.
Direct playback begins.
%
• While DSD signals are played back, “DSD DIRECT” is displayed.
• This can be set by pressing PURE DIRECT on the main unit.
Pure Direct playback
This mode is for playback with higher sound quality than in “DIRECT”
mode, by turning off the front panel display panel, which can eliminate
faint low level noise from creeping into sensitive analog circuitry.
1 Press PURE to select “PURE DIRECT”.
The display goes dark, and Pure Direct playback begins.
The PURE DIRECT indicator lights.
%
• In DIRECT and PURE DIRECT sound modes, the following items cannot be
adjusted.
• Tone (vpage 148)
• M-DAX (vpage 148)
• MultEQ® XT (vpage 150)
• Dynamic EQ (vpage 150)
• Dynamic Volume (vpage 151)
• This can be set by pressing PURE DIRECT on the main unit.
NOTE
• Video signals are only output when HDMI signals are played in the PURE DIRECT
mode.
• When the PURE DIRECT mode has been selected, the display turns off after about
5 seconds.