Kleenmaid KED2000 - Manual (Page 28)

28
Degree of drying has not been reached
or the drying time is too long.
Di l i di t E 03
Moisture sensor dirty. Clean moisture sensor as described on Page 26.
Switch off/switch on again.
Display may indicate E:03.
Exhaust air duct is blocked or too long. Clean exhaust air extraction. Reduce exhaust air duct
to maximum length as described on Page 7.
Switch off/switch on again.
Filter dirty. Clean filter as described on Page 25.
Switch off/switch on again.
Laundry was too wet. Spin laundry at higher speed in the washing
machine. Switch off/switch on again.
Unsuitable program selected. Select program with aid of the Program selection
table (see Page 19). Switch off/switch on again.
Maximum drying time was exceeded. Clean filter (see Page 25).
Check exhaust air extraction.
Spin laundry at a higher speed in your washer.
Motor limit temperature was exceeded. Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
Degree of dryness not correct set. Change settings for degree of dryness, see Page 17.