Kleenmaid KED2000 - Manual (Page 10)

10
Accessories
The parts required for the exhaust air
system can be obtained from customer
service or your local dealer. Please follow
the installation instructions supplied
by the appropriate manufacturer!
Left hinge kit
part no. WTZ1260
The door catch can be reversed
if necessary. The door is hinged
on the right at the factory.
Pedestal Mounting Kit
Part no.: WMZ20400
If mounting the dryer on the pedestal,
follow the instructions supplied with
the pedestal.
Installation ć
step by step
1. Unpack the dryer.
2. Remove all objects from the drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location.
5. If required,change the door hinges
to the left (see Page 10).
6. If required, have customer service
install the exhaust air outlet on the
dryer (see Page 7)
7. Install exhaust duct, if necessary.
Follow the installation instructions
supplied by the appropriate
manufacturer!
i If space is very restricted, it is
recommended to fit the initial parts
of the exhaust duct to the dryer
before the dryer is moved to its
final installation location.
8. Move the dryer to its final location
and align.
The dryer should be level with all
four feet firmly on the ground. The
dryer must not wobble. Adjust the
heightĆadjustable feet until the dryer
does not rock and is level, both
frontĆtoĆback and sideĆtoĆside.
9. Connect the exhaust duct to the
exhaust air outlet on the dryer.
10. Insert the mains plug into the
socket.
Preparing to transport
the dryer ć step
by step
1. Rotate the program selector
to Off.
2. Pull out power supply plug.
3. Disconnect the exhaust duct from
the exhaust air outlet on the dryer.
4. Place any accessories in the drum.
5. Close the door and secure with
adhesive tape.
6. Screw the heightĆadjustable feet of
the dryer into the housing to prevent
them from being damaged during
transportation.