Kleenmaid KED2000 - Manual (Page 26)

26
Cleaning the moisture
sensor
The moisture sensor has to be cleaned
because a fine layer of transparent
buildĆup is deposited on the sensors.
This deposit can easily be removed by
wiping the sensors (the two bars next
to the filter) with a cloth and a little white
vinegar.
Use white vinegar only!
Clean the moisture sensor once
a month.
d Do not use steel wool or abrasive
materials.
Cleaning the bearing
shield
Over time, fluff from the drying process
collects in the bearing shield.
This fluff can be easily removed using
your vacuum cleaner, at least once
a month.
Change the light bulb
The dryer light turns on inside the drum
when you open the door.
To change the light bulb:
q Set program selector to Off.
q Pull out power supply plug.
q Open the dryer door. The light
is located on the upper left side
of the door opening
q Loosen the screw of the cover and
open the cover.
q Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb (only obtainable
through customer service).
q Replace the cover and secure with
the screw.
q Replace the mains plug into the
socket.