Kleenmaid KED2000 - Manual (Page 25)

25
Cleaning and care
Cleaning the dryer
d The appliance must be switched
off!
Only wipe the housing and the fascia
with a damp cloth and soapy water.
Do not use strong detergents or
solvents.
Wipe the drum, door seal and inside
of the door with a damp cloth only.
Cleaning the filter
A dirty filter extends the drying time
and increases energy consumption.
The filter should be cleaned after and
before every drying process.
If a warning signal and an E01 warning
message are emitted during a drying
program, or the Filter indicator light
flashes, clean the filter immediately and
check the exhaust duct.
i The program interrupts
automatically.
1. Switch off the dryer. Program
selector to Off.
d Drum and door may be hot!
2. Open the dryer door.
3. Remove the filter.
4. Remove lint by stroking your hand
over the filter.
The filter should be lightly scrubbed
twice a year with warm soapy water.
The filter is cleaned when it no longer
holds water. The filter must be dried
thoroughly before being replaced.
5. Insert the filter.
6. Close the door.
Cleaning the exhaust
duct
Inspect and clean the exhaust ducting
at least once a year to prevent
clogging. A partially clogged exhaust
can lengthen the drying time.
q Turn the programme selector to
the Off position.
q Pull out power supply plug.
q Disconnect the duct from the
dryer.
q Vacuum and reconnect the duct.