Kleenmaid KED2000 - Manual (Page 27)

27
Troubleshooting
Before calling the customer service,
check whether you can rectify the fault
yourself by means of the following
table.
If a fault cannot be rectified or a repair
is required:
1. Set program selector to Off.
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Call customer service
(see Page NO TAG).
Problem Possible cause Remedial action
Dryer does not start. Main plug not inserted at all or not inserted correctly. Insert main plug correctly.
Start/Pause indicator light does not
ill i t
A fuse of power supply has tripped. Replace/switch on fuse.
illuminate.
Start/Pause button not pressed. Press Start/Pause button.
No program selected. Select program.
Door not closed. Close door.
In TimeĆPrograms duration not chosen. Chose time via Select button.
Ambient temperature below 5 °C. Increase room temperature.
Program has been interrupted.
A warning signal is emitted and the
di l h E 01 d/ th Filt
Filter dirty. Clean filter as described on Page 25.
Switch off/switch on again.
display shows E:01 and/or the Filter
indicator light flashes.
Exhaust air duct is blocked. Clean exhaust air extraction.
Switch off/switch on again.
Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min.
Switch on again.
Restart program.
The room/cabinet is not adequately ventilated. Provide an adequate supply of fresh air.
Switch off/switch on again.
Drum light does not function. No program selected. Select program.
Light bulb defective, light bulb burned out. Change light bulb, see Page 26.
No power supply. Guarantee power supply.
Light bulb is loose. Tighten light bulb. Remove and reinstall the cover
as directed on Page 26.
Start/Pause indicator light does not
illuminate. Anti Crease/end indicator
Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min.
Switch on again.
lights.
The display shows 0:00.
g
Restart program.