Kemppi Pulse 350 - Manual (Page 22)

EN
5. KF 62 pAnEl Button FunCtIons
POWER
WISE
PULSE
CHANNEL
1-MIG
SAVE
ROBOT
PANEL
CONTROL
MIG
DOUBLE
PULSE
U
A s
V m/min
mm
KF 62
W004330
+ / –
the control panel is used for controlling and monitoring the operation of the power source
and the wire feeder. the buttons are used for adjusting functions. the displays and indicators
reflect the operating modes of the machine.
displays
• the control panel displays show adjustable operation parametres, their values, and the
units of measure.
• During welding, display 2 shows the welding current value that is currently in use, while
display 6 shows the welding voltage.
Control knobs
• the left-hand control knob allows the adjustment of the speed of wire feeding. the
selected speed is shown on the display on the left-hand side.
• the right-hand side control knob allows for controlling the welding voltage in mig and
1-mig processes, in which case the selected voltage is shown on the right-hand side
display, and the base current in Wiseroot-a and Wisethin-a processes, in which case the
adjustment range is +/- 50.
these control knobs are also used for specifying the operating parametres. a parametre for
adjustment is selected with the left-hand knob, while the value of the parametre is selected
with the right-hand knob.
5.1 on / oFF Button
1.
Short press: panel returns to default display.
long press: When Welding panel (KF 62) is On => Welding panel is turned OFF. When Welding
panel (KF 62) OFF => welding panel is turned On and Setup panel (K 60) turns On and selects
automatically that Welding panel (WF#).
20
Kemp
a
rc
pulse 350, 450 / © Kemppi O
y / 1044