Kemppi Pulse 350 - Manual (Page 15)

EN
douBlE pulsE mIg
WFSpeed 0.7 – 25 m/min 0.05 m/min steps when WFSpeed < 5 m/min and
0.1 m/min steps when WFSpeed > 5 m/min
WFS-Max Set the limit for maximum WFSpeed
WFS-Min Set the limit for minimum WFSpeed
FineTuning Factory setting is 0
( = curve point)
Adjusts the base current of the curve in certain limits.
In other words, it adjusts the length of the arc in certain
limits.
FineTuningMax 0 – 9 0.5 steps Set the limit for maximum arc length
FineTuningMin -9 – 0 0.5 steps Set the limit for minimum arc length
Dynamics -9 – 9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
Pulse Current -10% – 15% Factory Setting
is 0%
Reduces the pulse current of the curve at the maximum
10% and raises it at the maximum 15%
DPulseAmp 0.1 – 3.0 m/min Factory setting is
CURVE
Adjusts the amplitude of the WFSpeed in 0.1 m/min
steps. Value comes from Welding Curve.
DPulseFreq 0.4 – 8.0 Hz Factory setting is
CURVE
Adjusts the frequency of the double pulse in 0.1 Hz
steps. Value comes from Welding Curve.
wIsEroot / wIsEthIn )
WFSpeed 0.7 – 14 m/min 0.05 m/min steps when WFSpeed < 5 m/min and
0.1 m/min steps when WFSpeed > 5 m/min
WFS-Max Set the limit for maximum WFSpeed
WFS-Min Set the limit for minimum WFSpeed
BaseCurrent Adjusts the base current of the curve in certain limits. In
other words, it adjusts the “length of the arc” in certain
limits.
BaseCurrentMax 0 – 50 % 1% steps Set the limit for maximum “arc length”
BaseCurrentMin -50 – 0 % 1% steps Set the limit for minimum “arc length”
FormingPulse Adjusts the forming pulse current of the curve in certain
limits. In other words, it controls arc pressure.
FormingPulseMax 0 – 50 % 1% steps Set the limit for maximum forming pulse current
FormingPulseMin -50 – 0 % 1% steps Set the limit for minimum forming pulse current
StartTime -9 – 9 Factory setting is
CURVE
Set how long arc behaves like normal synergic MIG/
MAG prosess after the arc start. It gives heat for the arc
start.
StartVoltage Set the arc voltage which is used during StartTime.
In other words, it adjusts the length of the arc during
StartTime.
13
Kemp
a
rc
pulse 350, 450 / © Kemppi O
y / 1044