Kemppi Pulse 350 - Manual (Page 16)

EN
4.3.2 welding functions
othEr proCEssEs (in edit Channel menu 3/6)
HotStart ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
HOTStartLevel -50 – 100 % 1 % steps. Factory setting 40 %
Hot 2T Time 0 – 9.9 s 0.1 s steps. Factory setting 1.2 s
CraterFill ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
CraterStart 10 – 250% Factory setting is 100% Set the level of the curve where the crater
filling will start
CraterFillEnd 10 – 250 %, not
higher than start
1 % steps. Factory setting 30% Set the level of the curve where the crater
filling will end.
CraterTime 0.0 – 10.0 s 0.1 s steps. Factory setting 1.0 s CrateFill Slope Time
Creep Start 10 – 99% 1% steps. OFF, CURVE
(OFF = 100%)
Factory setting is CURVE (Creep Start value
comes from Welding Curve).
StartPower -9 – 9 Factory setting is 0 Adjusts arc ignition
wIsEroot / wIsEthIn
HotStart ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
HOTStartLevel -50 – 100 % 1 % steps. Factory setting 40 %
Hot 2T Time 0 – 9.9 s 0.1 s steps. Factory setting
1.2 s
CraterFill ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
CraterStart 10 – 250% Factory setting is 100% Set the level of the curve where the crater
filling will start.
CraterFillEnd 10 – 250 %, not
higher than start
1 % steps. Factory setting 30%
CraterTime 0.0 – 10.0 s 0.1 s steps. Factory setting
1. 0 s
Creep Start 10 – 99% 1% steps. OFF, CURVE
(OFF = 100%)
Factory setting is CURVE (Creep Start value
comes from Welding Curve).
AdVAnCEd FunCtIons
WisePenetration ON or OFF Penetration control selection
Penet%(123A) -30 – 30 % Factory setting: 0 % Wise penetration percent setting. Set
penetration Current.
WiseFusion ON or OFF WiseFusion selection
WiseFusion% 20 - 60 % or CURVE Factory setting is CURVE When WISE FUSION is ON it controls the
amount of short circuits in the arc. The
lower the value there will be less short
circuits in the arc. The higher the value
there will be more short circuits in the arc.
MatchLogLevel -50 – 100% Set the “MiniLog level”
Only in use in case of manual feeder.
14
Kemp
a
rc
pulse 350, 450 / © Kemppi O
y / 1044