Exclusive data, Sound/setup program/bank, Midi implementation – Kawai MP10 User Manual
Page 84: System realtime message
84
Ap
p
e
n
d
ix
3. System Realtime Message
Status
FAH
Start
FBH
Continue
FCH
Stop
*Sending by [TRANSPORT] function
3
Exclusive Data
MMC commands
*Sending by [TRANSPORT] function
*Transmit only
F0 7F
device ID: 00H - 7FH
command:
01:STOP, 02:PLAY, 03:DEFERRED PLAY, 04:FAST FORWARD, 05:REWIND, 06:RECORD STROBE, 07:RECORD EXIT,
08:RECORD PAUSE, 09:PAUSE, 0A:EJECT, 0B:CHASE, 0C:COMMAND ERROR RESET, 0D:MMC RESET
4
SOUND/SETUP Program/Bank
If the Receive Mode MIDI parameter is set to Panel (page 46), the MP10 receives MIDI data on the System Channel
only. To change internal sounds via MIDI, please refer to the SOUND Program Number list below.
* Note: If the MP10 receives the Program Number from 1 to 128 and Bank number MSB 0 or 1 in the System Channel, the MP10 will switch to SETUP mode and
the corresponding SETUP is recalled. When the Receive Mode is Section, the MP10 can be received to each internal sound sections individually.
Panel Mode:
SETUP Program Number
BANK#MSB
1:
SETUP mode ON
BANK#LSB
0-25:
BANK A-Z
PROGRAM
0-5:
Setup Variation 1-6
SOUND Program Number
BANK#MSB
0:
SETUP mode OFF
BANK#LSB
0:
PIANO Section
1:
E.PIANO Section
2:
SUB Section
PROGRAM
0-8:
Sound variation 1-9
* Only one sound section is activated.
Section Mode:
BANK#MSB
(ignored)
BANK#LSB
(ignored)
PROGRAM
0-8:
Sound variation 1-9
*For each section’s Receive Channel.
*Not related to Setup ON/OFF.
MIDI Implementation