Overview of the edit menu, Ed it m e nu, Piano, e.piano, sub parameters – Kawai MP10 User Manual
Page 34: Midi parameters
34
E
D
IT
M
e
nu
Overview of the EDIT Menu
The EDIT menu contains various parameters that can be used to adjust the MP10's sound and MIDI sections. The
parameters are grouped by category, allowing close control over the instrument with just a few button presses.
This collection of parameters, together with other adjustable settings, can be stored as a SETUP memory (page 50).
The MP10 provides 26 banks x 6 setups, for a total of 156 user programmable setup memories.
PIANO, E.PIANO, SUB parameters
Page No.
Category
Parameters
1
REVERB
Type, Pre Delay, Time, Depth
2
EFX
Type, Parameters
(depends on EFX type)
3
VirtTech
(PIANO)
Voicing, Stereo Width, String Resonance, Damper Resonance, Key-off Effect,
Damper Noise, Hammer Delay, Fall Back Noise, Brilliance
AMP
(E.PIANO)
Amp Type, Drive, Level, Amp EQ
Layer
(SUB)
Sweep, Bell
4
Tuning
Fine Tune, Stretch Tuning, Temperament, Key of Temperament
5
KeySetup
Touch Curve, Octave Shift, KS-Damping/KS-Key, Split/Split Point,
Key Off Noise
(E.PIANO)
, Key Off Delay
(E.PIANO)
, Dynamics
(SUB)
6
Control
Damper Pedal, Damper Pedal Mode, Left Pedal, Left Pedal Assign, Pitch Bend,
Bend Range, Modulation Wheel, Modulation Wheel Assign, Expression Pedal,
Expression Pedal Assign, Foot SW, Foot SW Assign
7
KnobAsgn
n/a
8
Sound
Attack Time, Decay Time, Sustain Level, Release Time, Filter Resonance,
Filter Cut-Off, Panpot, Volume
Unless stated, parameter settings for the PIANO, E.PIANO, and SUB sound sections are independent for each section.
Parameters marked with a icon are common for all three sections.
MIDI parameters
Page No.
Category
Parameters
1
Program
Program, Bank MSB/LSB
2
Transmit
(SYSTEM)
Send Program, Send Bank, Send Volume, Send Knobs, Transmitting Recorder
3
Receive
(SYSTEM)
Recieve Mode, PIANO Channel, E.PIANO Channel, SUB Channel
4
MMC
(SYSTEM)
MMC Dev. ID, MMC Commands
5
KeySetup
Touch Curve, Octave Shift, Split/Split Point, Dynamics, Solo, Transmit
6
Control
Damper Pedal, Left Pedal, Left Pedal Assign, Pitch Bend,
Bend Range, Modulation Wheel, Modulation Wheel Assign, Expression Pedal,
Expression Pedal Assign, Foot SW, Foot SW Assign
7
KnobAsgn
n/a
Parameters for the MIDI section marked with a
icon are SYSTEM parameters and memorised automatically.