JLCooper eBOX - Manual (Page 23)

23
Status Window
This window shows additional status messages of the connection
to the eBOX you want to configure. In addition, you will also see
the firmware version of the connected eBOX.
eBOX Programming
The parameters in this box are settings that will be downloaded
into the eBOX.
eBOX IP address
This will be the IP address of this eBOX when SW1, SW2 and
SW3=On.
Subnet Mask
This will be the subnet mask of the eBOX.
Gateway Address
This will be the IP address of gateway router which connects to
other networks.
Port Number
This will be the TCP port of this eBOX when SW1, SW2 and
SW3=On.
Destination IP Address
IP address of remote eBOX when SW1, SW2 and SW3=On. This
is used when eBOX is configured in the GPI to Ethernet mode or
the eBOX is in client mode.
Destination Port Number
TCP port of remote eBOX when SW1, SW2 and SW3=On. This is
used when eBOX is configured in the GPI to Ethernet mode or the
eBOX is in client mode.
Auto Calculate Checksum
Automatically appends a Sony type checksum to the end of each
message.
Suppress Header and Status Request
This disables Doremi message headers and VTR status requests.
Doing this allows you to use the eBOX in applications that do not
involve a VTR.
Serial Ports Baud Rate
Sets the port rate of the individual serial ports.