JLCooper eBOX - Manual (Page 10)

Resetting eBOX Settings
The eBOX settings can be forced to factory defaults by using the
reset button. The reset button is located behind the front panel. It
can be accessed via the small, unmarked hole to the right of the
Port 4 Send LED. The arrow in the picture below shows the
location of the hole for the reset button.
To reset the eBOX to factory defaults, simply press the button with
a long, thin object such as a paper clip and turn the power on. The
reset button can be released after the 5 Send and 5 Receive LEDs
stop flashing.
The eBOX factory defaults are:
IP Address 192.168.254.102
Subnet Mask 255.255.255.0
Gateway Address 192.168.254.198
TCP Port 23
Destination IP Address 192.168.254.103
Destination TCP Port 5000
Password password
Serial Port Rate 38400 bits/sec
Parity Odd
Serial Port Timeout
5 mS
Maximum Buffer Size 128 bytes
eBOX Settings After Reset
After the eBOX settings are reset in this manner, you must power
cycle the eBOX to load those settings.
10