JLCooper eBOX - Manual (Page 14)

14
eBOX Settings
This section allows you to change the operational settings of the
eBOX Ethernet and serial ports. These settings are identical to the
settings that appear on the configuration web page.
Device IP Address
IP address of this eBOX when SW1, SW2 and SW3=On.
Subnet Mask
The mask is a binary pattern that is matched up with the IP address
to turn part of the host ID address field into a field for subnets.
Gateway Address
IP address of gateway router that connects to other networks.
Port Number
TCP port of this eBOX when SW1, SW2 and SW3=On.
Destination IP Address
IP address of remote eBOX when SW1, SW2 and SW3=On. This
is used when eBOX is configured as a client (SW7=On).
Destination Port Number
TCP port of remote eBOX when SW1, SW2 and SW3=On. This is
used when eBOX is configured as a client (SW7=On).
Password
Eight character alphanumeric password that is embedded in the
Ethernet packet that prevents unauthorized eBOXes from passing
unintended packets. If the password protection feature is enabled
(SW6=Off) on either eBOX, then both eBOXes must have the
same password.
Baud Rate
Sets the port speed of the individual serial ports.
Parity and Parity Type
Enables or disables parity and sets parity type of the serial ports.
Serial Time Out
Sets the time that the eBOX will wait for data from the serial ports.
Max Buff Size
Sets the maximum buffer size of the serial ports.