Ivoclar Vivadent IPS e.max CAD Chairside User Manual
Page 27
27
Staining Technique
Clean off any possible residue adhering to the outer surface of the crown with a brush
dampened with water and dry
Smooth out displaced IPS Object Fix Putty or Flow with a plastic spatula from the margin
towards the support pin so that the pin is secured in the paste and the crown wall is exactly
supported
Press the selected IPS e.max CAD Crystallization Pin deeply into the
IPS Object Fix Putty or Flow
Fill the inside of the crown with IPS Object Fix Putty or Flow.
Adapt IPS Object Fix Putty or Flow exactly to the margins
Thoroughly clean off contamination with a brush dampened with water and dry
Press the suitable IPS e.max CAD Crystallization Pin into the Putty or Flow material
Apply a small amount of IPS Object Fix Putty or Flow to the inner side of the restoration
Preparation of the veneer, inlay, onlay for the application of the glaze spray
If the Glaze Spray is used to glaze veneers, inlays and onlays, the restorations must be supported by auxiliary firing
paste on the inner side. This is to prevent that Glaze Spray is applied to the inner side.