E.max, Staining technique – partial crowns, crowns – Ivoclar Vivadent IPS e.max CAD Chairside User Manual
Page 24

24
IPS e.max CAD LT blocks are ideally suitable for the fabrication of larger restorations (partial crowns, crowns) on prepared
teeth that are not or only slightly discoloured. Due to the higher brightness compared with IPS e.max CAD HT, a
“greying“ of the restoration is prevented.
Individualized characterizations and glaze are applied before the combined Crystallization and Glaze firing is conducted.
Because of the combined firing, processing is very efficient and leads to a highly esthetic result quickly and easily.
Preparation
After the determination of the tooth shade, preparation is carried out according to the preparation guidelines. As a
preparation for intra-oral imaging, the cleaned and dried preparation is covered with IPS Contrast Spray Chairside
(blue-lemon or cream-lemon) with one short spray discharge.
e.max
®
CAD
Staining Technique – Partial Crowns, Crowns
IPS
Initial situation: The crown on tooth 37 has to be replaced
Preparation: occlusal view
Preparation: buccal
Preparation sprayed with IPS Contrast Spray Chairside cream-lemon;
ready for intraoral recording
For information on the CAD/CAM processing, please refer to the respective Instructions for Use and the
manuals of the respective CAD/CAM system. The instructions of the manufacturers must be followed.
The suitable IPS e.max CAD Block is selected on the basis of the desired tooth shade
and the determined shade of the prepared tooth.
Please refer to the table on page 49 for block selection.