Ivoclar Vivadent Telio CS - Manual (Page 35)

Subsequent adjustments
Supplementing Telio CAD restorations
Roughen the area to be supplemented or repaired by grinding and then wet extraorally with Telio
Activator. Agitate Telio Activator for at least 30 seconds over the entire surface using an application brush
in order to achieve even distribution and quicker penetration. Subsequently, allow the Activator to react
for another 30-60 seconds (total reaction time 1-2 minutes). Now apply the Heliobond bonding agent,
thinly disperse it with blown air, and polymerize for 10 seconds (650 mW/cm
2 e.g. bluephase using LOP).
Apply Telio Add-On Flow or another light-curing Ivoclar Vivadent composite (e.g. Tetric EvoFlow, Tetric
EvoCeram) and cure according to the Instructions for Use.
Add-ons and relines with Telio Add-On Flow
Relines and supplements of Telio Lab and Telio CAD restorations can be carried out using Telio Add-On
Flow.
– Roughen the desired area of the Telio Lab / Telio CAD restoration with rotary instruments / diamonds.
– Then wet the roughened area (extraorally!) with Telio Activator.
Agitate Telio Activator for at least 30 seconds over the entire surface using an application brush in
order to achieve even distribution and quicker penetration. Subsequently, allow the Activator to react
for another 30-60 seconds (total reaction time 1-2 minutes). Now apply a thin layer of Heliobond
bonding agent with a brush, ball-shaped instrument, or using the snap-on plastic cannula, thinly
disperse it with blown air, and polymerize for
≥10 seconds
(>650 mW/cm 2 e.g. bluephase using the LOP mode).
– Then apply Telio Add-On Flow and subsequently polymerize using a high-performance curing light
(>1000 mW/cm 2 ; e.g. bluephase) for 15 seconds per segment, or a standard curing light
(>500 mW/cm 2 ) for 30 seconds per segment.
– As an alternative, other light-curing Ivoclar Vivadent composites (e.g. Tetric EvoCeram) can be used.
G
e
n
e
ra
l
In
fo
rm
a
ti
o
n
35