Ivoclar Vivadent Telio CS - Manual (Page 14)

14
5. The material is mixed and dispensed through
the mixing tip by pulling the trigger and can be
applied directly into the matrix.
Removal of the cartridge
Lift the release lever below the plunger on the back and pull the plunger as far back as possible.
Lift the cartridge lock on the front side on top of the dispenser and remove the cartridge.
Leave the used mixing tip on the syringe as a cap until the next application.
Application
Telio CS C&B is automatically mixed when it is dispensed directly into the impression or vacuum-formed
matrix with slight pressure. Prior to each application, extrude and discard an approximately pea-sized
amount of material.
Telio CS C&B is automatically mixed when it is dispensed directly into the impression or vacuum-formed
matrix with slight pressure.
To prevent voids, apply the material to the occlusal surfaces first, then proceed by filling the gingival areas.
Keep the mixing tip immersed in the material to prevent bubbles. If required, the material may also be
syringed around the prepared teeth to avoid bubble formation along the preparation margin. The
processing time is approx. one minute at room temperature (23 °C / 73 °F).
Discard a pea-sized amount of Telio CS C&B.