Ivoclar Vivadent Telio CS - Manual (Page 30)

30
Finishing
Use (fine) cross-cut tungsten carbide burs to finish Telio CAD blocks.
Observe the following procedure for finishing Telio CAD restorations:
– Use cross-cut tungsten carbide burs to smooth out the attachment point.
– Carry out shape adjustments with cross-cut tungsten carbide burs or customary diamonds.
– Overheating of the material must be avoided.
– Surface-grind the entire occlusal surface with a fine diamond to smooth out the surface texture
created by the CAD/CAM procedure.
– Make sure that the minimum thicknesses are maintained even after the minor adjustments.
– Make sure to thoroughly clean the restoration before further processing and to remove any residue of
the milling additive of the CAD/CAM milling unit. Residue of the milling additive remaining on the
surface may result in bonding problems.
– Try in the restoration and adjust the occlusion/articulation, if necessary.
Finishing with tungsten carbide burs… ... and disks