Polishing – Ivoclar Vivadent Telio CS User Manual
Page 31
Te
li
o
C
A
D
–
F
u
ll
y
a
n
a
to
m
ic
a
l
fa
b
ri
ca
ti
o
n
a
n
d
fi
n
a
l
p
o
li
sh
in
g
31
Polishing
Careful polishing is the prerequisite for an optimum esthetic result. Polishing reduces plaque accumulation
and the resulting shade disturbances. Pay special attention to crown margins, interdental areas, occlusal
surfaces and the basal rest area of pontics.
In order to achieve a lifelike surface gloss, please observe the following procedure:
– Use the appropriate speed (7500-10,000 rpm) and water spray for the polishing.
– Avoid an excessive heat build-up.
Polishing is carried out with the 3-step polishing system Astropol F, P and HP:
1
st
step: Finishing with Astropol F (grey)
With the Astropol F finisher, excess is removed and a smooth surface can be achieved.
2
nd
step: Polishing with Astropol P (green)
Polishing with Astoropol P results in a very delicate surface finish.
3
rd
step: High-gloss polishing with Astropol HP (pink)
With the microfine Astropol HP diamond finisher, a high gloss can be achieved quickly. Do not apply
pressure.
Polishing with Astropol
Seated Telio CAD restoration
Completed Telio CAD restoration
Alternatively, the single-step polishing system OptraPol can be used.