Ivoclar Vivadent IPS e.max CAD Labside User Manual
Page 34

Firing parameters for the Stain and Characterization firing, Glaze firing
IPS e.max Ceram on IPS e.max CAD
B
S
t
➚
T
H
V1
V2
Staining Technique
[°C/°F]
[min]
[°C/°F/min]
[°C/°F]
[min]
[°C/°F]
[°C/°F]
Stain and Characterization firing
403/757
6:00
60/108
770/1418
1:00 -2:00
450/842
769/1416
Glaze firing
403/757
6:00
60/108
770/1418
1:00 - 2:00
450/842
769/1416
Completed IPS e.max CAD LT crown after Glaze firing
34
Stain and Glaze firing
After the restoration has been cleaned, the Stain and Glaze firing is conducted. Use IPS e.max Ceram Shades, Essences and
Glaze for these firing procedure.
– IPS e.max Shades are ready-to-use stains in syringes.
– IPS e.max Ceram Essences are intensively shaded powdered stains, which are mixed with IPS e.max
Ceram Glaze and Stain Liquid.
– IPS e.max Ceram Glaze Paste is a ready-to-use glaze paste supplied in a syringe.
– IPS e.max Ceram Glaze Spray is a ready-to-use glaze spray.
Please observe the following procedure:
– Depending on the situation, the Stain and Glaze firing may be conducted together or separately one after
the other. A separate Stain firing permits exact shade match with the given clinical situation.
– If more pronounced characterizations are required, a separate Stain and Characterization firing is
recommended, rather than the application of a thicker stains layer. Conduct it as a second firing after Glaze firing.
Application of IPS e.max Ceram Glaze before Glaze firing.
Application of IPS e.max Ceram Essences and Shades before the Stain and Characterization
firing.