Ivoclar Vivadent IPS e.max CAD Labside - Manual (Page 17)

17
O
v
e
rv
ie
w
o
f
th
e
C
li
n
ic
a
l
W
o
rk
in
g
S
te
p
s,
F
a
b
ri
ca
ti
o
n
P
ro
ce
ss
CAD/CAM processing
As densification of about 0.2% takes place in IPS e.max CAD during the crystallization process. This factor has been taken
into account in the software. Consequently, the milled IPS e.max CAD restorations demonstrate precision of fit after
crystallization. The fabrication steps are described in the directions for use and user manuals of the different CAD/CAM
systems. The instructions of the manufacturers must be followed:
Information is available from:
Sirona Dental Systems GmbH
Fabrikstrasse 31
64625 Bensheim
Germany
E-mail: [email protected]
www.sirona.com
inLab ® is a registered trademark of Sirona Dental
Systems GmbH
Information is available from:
KaVo Dental GmbH
Bismarckring 39
88400 Biberach
Germany
E-mail:[email protected]
www.kavo-everest.com
Everest ® is a registered trademark of
KaVo Dental GmbH
Information is available from:
Institut Straumann AG
Peter Merian-Weg 12
4052 Basel
Switzerland
E-mail:[email protected]
www.straumann.com