Ivoclar Vivadent IPS e.max CAD Labside - Manual (Page 33)

33
S
ta
in
in
g
Te
ch
n
iq
u
e
Die fabrication with IPS Natural Die Material
The light-curing IPS Natural Die Material simulates the shade of the preparation. Fabricate a die according to the shade
information supplied by the dentist (shade selection), which serves as the optimum basis for a true-to-nature shade
reproduction of the given oral situation. Please observe the following procedure:
– Coat the inner surfaces of the ceramic restoration with IPS Natural Die Material Separator and allow it to react for a
short time.
– Apply the selected IPS Natural Die Material on the inner aspects of the restoration using the IPS Condenser. Make sure
that the entire inner aspect is covered and filled.
– Insert the IPS Die Holder into the material and adapt excess around the die holder. Make sure that there is no gap at the
restoration margins.
– Cure the IPS Natural Die Material die in a customary light polymerization device for 60 seconds.
– If necessary, the die can be further finished and smoothed after polymerization.
Coat the inner surfaces of the ceramic restoration with IPS Natural Die Material Separator
and allow it to react for a short time. Apply IPS Natural Die Material in the restoration and place the die holder.
Cure in a customary light polymerization device.